
12 Models 8751/8754Important: Tothe Operator
WASH K eyWhen the WASH key is pressed, the light c omes on.
This indicates beater motor operation. The STANDBY
or AUTO modes must be cancelled first to activat et he
WASH mode.
AUTO KeyWhen the AUTO key is pressed, the light comes on.
This indicates that the main refrigeration system has
been activated. In the AUTO mode, the WASH or
STANDBY functions are automatically cancelled. The
MIX REF function is automatically locked in t o
maintain the mix in the mix hopper.
Note: An indicating light and an audible tone will
sound whenever a mode of operation has been
pressed. Toc ancel any function, press the key again.
The light and mode of operation will shut off.
Pump KeyWhen the PUMP key is pressed, the light comes on,
indicating the air/mix pump will operate as required.
Reset ButtonThe reset button is located in the serv ice panel on the
front of the machine. The reset protects the beater
motor from an overload condition. I f an overload
occurs, the reset mechanism will trip. To properly reset
the freezer, press the AUTO key to cancel thecycle.
Turn the power switch to the OFF position. Press the
reset button firmly.
Do not use metal objects to p ress the reset
button. Failure to follow this instruction may
result in electrocution.
Turn the power switch to the ON position. Press the
WASH key and observe the freezer’s performance.
Open the side access panel. Make sure the beater
motor is turning the drive shaft in a clockwis e direction
(from the operator end) without binding.
If the beater motor is turning properly, press the WASH
keyto cancel the cycle. Press the AUTO key to resume
normal operation. If the freezer shuts down again,
contact a service technician. (For the Model 8754
presst he AUTO key on both sides of the unit to resume
normal operation.)
Air/Mix Pump Reset MechanismThe reset button for the pump is located in the service
panel. The reset protects the pump from an overload
condition. Should an overload occur, the reset
mechanism will trip. Toreset the pump, press the reset
button firmly.
Adjustable Draw HandleThese units feature an adjustable draw handle t o
provide the best portion control. The draw handle
should be adjusted to provide a flow rate of 5 to 7-1/2
oz. (148 to 222 ml) of product per 10 seconds. To
INCREASE the flow rate, turn the screw
COUNTERCLOCKWISE. Turn the screw
CLOCKWISE to DECREASE the flow rate. During
“Sanitizing” and “Rinsing”, the flow rate can be
increased by removing the pivot pin and placing the
restrictive bar on the TOP. When drawing product,
always place the restrictive bar on the bottom .
Figure 1
IMPORTANT:Once the draw rate is set, tighten the
lock nut with a wrench.