
15
Models 8751/8754 Operating Procedures
Step 2
Install the beater assembly. First check thescr aper
blades for any nicks or signs of wear. If any nicks are
present, or if the blades are worn, replace both blades .
If the blades are in good condition, install the scraper
blade clips on the scraper blades. Place the rear
scraper blade over the rear holding pin on the beater.
Note: The hole on the scraper blade must fit securely
over the pin to prevent costly damage.
Figure 5
Holding the rear blade on the beater, slide it halfway
intot he freezing cylinder. Install the front scraper blade
over the front holding pin.
Install the beater shoes.
Figure 6
Slide the beater assembly the rest of the way int o the
freezing cylinder.
Make sure the beater assembly is in position over the
drive shaft. Turn the beater slightly to be cer tain that
the beater is properly seated. When in position, the
beater will not protrude beyond the f ront of the freezing
cylinder.
Repeat steps 1 and 2 for theother side of the f reezer
on the Model 8754.
Step 3
Assemble the freezer door. Place the large rubber
gasket(s) into the groove(s) on the back side of the
freezer door.
Slide the white plastic front bearing(s) ov er the baffle
rod(s) onto the bearing hub(s) making c ertain that the
flangedend of the bearing is r esting against the freezer
door. DO NOT LUBRICATE THE GASKET(S) OR
THE FRONT BEARING(S).
Figure 7
Note: There are two gaskets and two front bearings
fort he Model 8754 door,one f oreac h freezing cylinder.
Figure 8