21
Models 8751/8754 Operating Procedures
Install the hex end of the drive shaft intothe driv e hub
at the rear wall of the mix hopper.
Figure 31
Note: For ease in installing the pump, position the ball
crank of the drive shaft in the 3 o’clock position.
Step 9
Lay the pump assembly, pump clip, mix feed tube,
locking clip, and gasket in the bottom of the mix hopper
for sanitizing.
Figure 32
Repeat Steps 1 through 9 for the other side of the
freezer on the Model 8754.
Sanitizing
Step 1
Prepare two gallons (7.6 liters) of an approved 100
PPM sanitizing solution (example: Kay-5r). USE
WARMWATER AND FOLLOW THEMANUFACTUR-
ER’S SPECIFICATIONS.
Step 2
Pour the two gallons (7.6 liters) of sanitizing solution
over all the parts in the bottomof the mix hopper and
allow it to flow into the freezing cylinder.
Figure 33
Note: Youhave just sanitizedthe mix hopper and
parts; therefore, be sure your han dsare cl ean and
sanitized before going on in t hese instructions.
Step 3
While the solution is flowing into the freezing cylinder,
take particular care to brush-clean the mix level
sensing probe on the front wall and the bottom of the
hopper,the mix hopper, the mix hopper gasket, t he mix
inlethole, t heair/ mix pump, the pump clip, the mix feed
tube, and the locking clip.