4Models C810 & C812Safety
Section 3 Safety
We, at Taylor Company, are concerned about the
safety of the operator when he or she comes in
contact with the grill and its parts. Taylor has gone
to extreme efforts to design and manufacture built-in
safety features to protect both you and the service
technician. As an example, warning labels have
been attached to the grill to further point out safety
precautions to the operator.
IMPORTANT - Failure to adhere to the
following safety precaution s may result in
severe personal injury or death. Fail ure to
comply with these warnings may damag e the
machineand its components. Component
damagewill result in part replacement expense
and service repair expense.

To Operate Safely:

DO NOT operate the grill without reading
this Operator's Manual. This manual should be kept
in a safe place for future reference.
Failure to follow the instructions below may
result in severe injury or death from electrocution:
SDO NOT operate the grill unless it is
properly grounded.
SDO NOT attempt any repairs unless the
power supply to the grill has been
disconnected (must be performed by an
authorized service technician).
SDO NOT operate the grill unless all service
panels are restrained with screws.
SStationary appliances which are not
equipped with a power cord and a plug or
other device to disconnect the appliance
from the power source, must have an
all-pole disconnecting device with a contact
gap of at least 3 mm installed in the external
installation.
SAppliances that are permanently connected
to fixed wiring and for which leakage
currents may exceed 10 mA, particularly
when disconnected or not used for long
periods, or during initial installation, shall
have protective devices such as a GFI, to
protect against the leakage of current,
installed by the authorized personnel to the
local codes.
SSupply cords used with this unit shall be
oil-resistant, sheathed flexible cable, not
lighter than ordinary polychloroprene or oth-
er equivalent synthetic elastomer-sheathed
cord (Code designation 60245 IEC 57), in-
stalled with the proper cord anchorage to
relieve conductors from strain, including
twisting, at the terminals and protect the in-
sulation of the conductors from abrasion.
IMPORTANT:DO NOT use a water jet or
spray excessive water on or anywhere near the
grill. Failure to follow this instruction may result in
serious electrical shock and cause permanent
electrical and mechanical damage to internal parts.
Failure to follow this instruction may result in:
Sserious electrical shock
Sburns from hot steam
Sliquid collecting inside the grill and
destroying electrical components