7
Models RD30/RC25 To the Operator
081029
Section 2 To the Operator
The freezer you have purchased has been caref ully
engineered and manufactured to give you dependable
operation. The Taylor Model RD30/RC25, when
properly operated and cared for, will produce a
consistent quality product. Like all mechanical
products, this machine will require cleaning and
maintenance. A minimum amount of care and
attention is necessary if the operating procedures
outlined in this manual are followed closely.
This Operator’s Manual should be r ead before
operating or performing any maintenance on your
equipment.
Your Model RD30/RC25 will NOT eventually
compensate and correct for any errors during the
set--upor fillingoperat ions. Thus, the initial assembly
and priming procedures are of extreme importance. It
is strongly recommended that all personnel
responsible for the equipment’s operation thoroughly
read this manual.
If you require technical assistance, please contact
your local authorized Taylor Distributor.
Note: Warranty is valid only if the parts are authorized
Taylor parts, purchased from an authorized Taylor
Distributor, and the required service work is pr ovided
by an authorized Taylor service technician. Taylor
reserves the right to deny warranty claims on
equipment or parts if non--approved parts or
refrigerant were installed in the machine, system
modifications were performed beyond fact ory
recommendations, or it is det ermined that the failure
was caused by neglect or abuse.
Note: Constant research results in stead y
improvements; therefore, information in this
manual is subjectto changewithout notice.
If the crossed out wheeled bin symbol is
affixed to this product, it signifies that this product is
compliant with the EU Directive as well as other similar
legislation in effect after August 13, 2005. Therefore,
it must be collected separately after its use is
completed, and cannot be disposed as unsort ed
municipal waste.
The user is responsible for returning the product to the
appropriate collection facility, as specified by your local
code.
For additional information regarding applicable local
laws, please contact the municipal facility and/ or local
distributor.

Compressor Warranty Disclaimer

The refrigeration compressor(s) on this machine are
warranted for the term indicated on the warranty c ard
accompanying this machine. However, due to the
Montreal Protocol and the U.S. Clean Air Act
Amendments of 1990, many new refrigerants ar e
being tested and developed, thus seeking their way
into the service industry. Some of these new
refrigerants are being advertised as drop--in
replacements for numerous applications. It shouldbe
noted that, in the event of ordinary service to t his
machine’s refrigerationsystem, only therefrigerant
specifiedon the affixed datalabel should be used.
The unauthorized use of alternate refrigerants will void
your compressor warranty. It will be the owner ’s
responsibility to make this fact known to any tec hnician
he employs.
It should also be noted that Taylordoes not warr antt he
refrigerant used in its equipment. For example, if the
refrigerant is lost during the course of ordinaryservice
to this machine, Taylor has no obligation to either
supply or provide its replacement either at billable or
unbillable terms. Taylor does have the obligation to
recommend a suitable replacement if the original
refrigerant is banned, obsoleted, or no longer available
during the five year warranty of the compressor.
Taylor will continue to monitor the industry and test
new alternates as they are being developed. Shoulda
new alternate prove, through our testing, that it would
beacc epted as a drop--inreplacement, then t heabove
disclaimer would become null and void. To find out the
current status of an alternate refrigerant as it relatesto
your compressor warranty, call the local Taylor
Distributor or the Taylor Factory. Be prepared to
provide the Model/Serial Number of the unit in
question.