Taylor RC25, RD30

Models RD30/RC25 Operating Procedures

Insert the torque rotor (guide bearing end first) into the

pilothole in the cent er of the drive shaft. The hole in the

torque rotor shaft should be rotated to the 12 o’clock

position.

Figure 12

Step 4

Install the freezerdoor. Slide the draw valv e o--ring

into the groove on the draw valve and lubric ate the

o--ring.

Figure 13

Place the draw valve spring over the shaft end on the

draw valve.

Figure 14

Insert the draw valve and spring into the door spout

until the threaded end of the shaft passes throughthe

hole in the end of the door spout. Thread the draw

valve knob onto the end of the draw valve shaft.

Figure 15

Contents

Main Page Table of Contents Table of Contents -- Page 2 Section 1 To the Installer Installer Safety S Site Preparation Electrical Connections S Beater Rotation Refrigerant Refrigeration Chargingand Line Construction Recommended System RefrigerantCharge Line Size Single Dispensing Installations Dual Dispensing Installations (One Condenser, Two Dispensers) Installation Refrigeration Connections Set Up Procedures Standard Fill Module Units Equipped With Post Mix Valve Section 2 To the Operator Compressor Warranty Disclaimer Section 3 Safety S 10 Models RD30/RC25Operator Parts Identificati on Section 4 Operator Parts Identification Model RD30 11 Models RD30/RC25 Operator Parts Identification Beater Door Assembly Section 5 Important: To the Operator Control Switch Fill Switch Mix Out Light Viscosity Control Section 6 Operating Procedures Assembly Page Page Page Sanitizing Page Page Priming Closing Procedure S S S S Draining Product From The Freezing Cylinder Rinsing Cleaning Disassembly Brush Cleaning S S S S S S S Section 7 Important: Operator Checklist During Cleaning and Sanitizing Troubleshooting Bacterial Count Regular Maintenance Checks Winter Storage Section 8 Troubleshooting Guide Page Page Section 9 Parts Replacement Schedule Section 10 Parts List RD30 Page Page Page Page Page RC25