TC electronic SDN BHD x32 user manual Parameters, Lock, Device, 1st audio channel, Calibrate

INTEGRATOR

The Integrator plug-in is automatically installed when the

TC Near control panel is installed.

Parameters

Lock

Green - indicates correct lock between the selected external digital device and Digital Konnekt x32.

Red - indicates “no lock”. Check connections and settings.

Device

Selects the connected digital devices you are setting up.

1st audio channel

Your DAW detects audio channels on the Digital Konnekt x32 and label these automatically. As the Integrator acts as a stereo plug-in interface between the DAW and external stereo devices, you always select two channel (by default). These are identified by the name of the first channel. In the illustration on the previous page, channel pair 9/10 is selected even though the label says “fw ch 9”.

When inserting Integrator on a mono track it still occupies a pair of channels.

Calibrate

Integrating external digital devices will introduce a short latency. But your host application can be set up to compensate for this using the calibrate function in the Integrator.

•Press CALIBRATE to measure the total roundtrip latency including the latency within the external device.

The latency compensation feature of the host application will then make sure to compensate for this latency.

This procedure should be carried out on each audio track where Integrator is inserted.

15