Teac G-0s owner manual Dimmer, Troubleshooting, Maintenance

Dimmer

The front display can be dimmed to suit your preferred environment. There are two levels and an “off” setting.

Press the A button for more than 2 seconds to switch the dimmer mode.

LEd OFF 1:

All the illuminations are turned off except the MASTER button indicator (Xtal, Rb, Ext).

LEd OFF 2:

All the illuminations are turned off.

LEd ON:

Normal mode.

<Note that the OFF setting is memorized when the power is turned off.

<In OFF mode, when you turn on the power or you operate other buttons, the illuminations turn temporarily on, and after the clock signal is stabilized, it turns off. (After the indicator for the MASTER button stops blinking and lights steadily.)

Troubleshooting

In case you experience any problem with this unit, please take the time to look through this chart and see if you can solve the problem yourself before you call your dealer or a TEAC service center.

No power

eCheck the connection to the AC power supply. Check and make sure the AC source is not a switched outlet and that, if it is, the switch is turned on. Make sure there is power to the AC outlet by plugging in another item such as a lamp or fan.

eTurn on the POWER switch on the rear panel.

Not synchronized

eCheck to see if the current word clock output is supported by the connected players. If necessary, select a word clock frequency that is appropriate for the individual players.

There are occasions where the word clock available for synchronization varies depending on the connection and settings of the individual players. For details, consult the manual for each player.

eIf you are using the PAL FILM mode, check to see whether the connected player supports the PAL FILM frequency (-4% of the standard frequency).

eCheck to see whether the sync outputs on the rear panel are connected to the acceptable sync inputs of the individual players.

Desired frequency not selectable with A, B, and C buttons

eSelect the proper fundamental frequency in FREQUENCY MODE before operating the buttons.

Odd sound pitch

eDo not use the PAL FILM mode for NTSC discs or PAL discs other than film source discs.

If normal operation cannot be recovered, unplug the power cord from the outlet and plug it in again. This resets the internal micro-computer which can be disturbed during electrical storms, power interruptions, et cetera.

Maintenance

If the surface of the unit gets dirty, wipe with a soft cloth or use diluted neutral cleaning liquid. Be sure to remove any fluid completely. Do not use thinner, benzine or alcohol as they may damage the surface of the unit.

10