Teac K1200 owner manual Using GPS and Aawd at the Same Time

volume control to do this (you need to receive a real transmission to do this) before the ride begins.

•AAWD or GPS volume level must be set high enough to trigger the audio circuit. Very low volume levels may produce a “choppy” audio response.

•A special plug kit with universal pigtail is available from your BMW retailer under BMW PN 99 99 0 000 194, to provide a quick connection to your AAWD. A three-conductor plug is mounted in the LH handlebar molded housing, allowing quick disconnection of your AAWD. If AAWD does not have an audio output signal connection, you can contact J & M Corporation at 520-624-7000 for information on the cost to modify your device to obtain the necessary connections.

Using GPS and AAWD at the Same Time

•Knowing that some users will want to have both devices active at the same time, separate connection points were developed in the wiring harness. These points will pipe both signals into the same channel inside the ComSystem, but will keep them from back-feeding into each-other. The plug connection for the GPS is near the CB radio plug connection. The connection point for the AAWD is inside the LH handlebar cover.

•It is recommended that the volume level of the AAWD be adjusted lower than the volume of the GPS. This way, the lower volume tone will be easily recognized, while the louder voice direction of the GPS will be distinguished from the lower AAWD tone.

Do not make adjustments to Accessory Audio Warning Device or GPS controls while driving.

Use of Accessory Audio Warning Devices may not be approved in all States. Please consult and observe all local regulations.

19