Wall Mounting

Remote Control Unit

You can mount the R-X1 on a wall.

Precautions

<Be aware of the best possible direction for receiving AM broadcasts (this unit has no AM anntena you can turn around).

<Leave sufficient space above the unit to extend the FM telescopic antenna.

<Pay attention to the length of the AC adaptor.

<Drill holes into solid wall support, such as wooden frame or concrete wall.

<TEAC supplies these brackets as a convenience to the product owner. Consult your local building codes and exercise all necessary caution when mounting these brackets. If you are unsure how to use the supplied brackets, consult with a local tradesmen or building supply expert.

To hook on the wall

1.Fix the brackets on the rear panel of the R-X1 using the supplied short screws.

2.If the AC adapter has not been connected, connect it to the DC IN jack of the R-X1.

3.Use the supplied guide sheet to mark the exact drilling points on the wall.

4.Drill holes in the wall at the marked points.

5.Screw the supplied long screws into the wall.

Leave about 5 mm space between the screw’s head and the wall.

<As a convenience, a set of tapered plastic anchors is supplied. If you chose to use these anchors, drill a pilot hole using a 6 mm drill bit then tap the anchor into the pilot hole.

Only use these anchors if they are appropriate for the materials onto which the unit is to be mounted. Consult your local hardware store if you are uncertain.

6.Carefully hang the R-X1 onto the screws.

Note:

<Ensure that the unit locks onto the hooks and that the hooks are strong enough to support the weight before removing your hands.

The provided Remote Control Unit allows the unit to be operated from a distance. When operating the remote control unit, point it towards the remote sensor on the front panel of the unit.

<Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control.

<If the remote control unit is operated near other products which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the other products may also operate incorrectly.

Battery Installation

1

2

3

1.Remove the battery compartment cover.

2.Put in the lithium battery (CR2032, 3V).

3.Close the cover.

Battery Replacement

If the distance required between the remote control unit and main unit decreases, the battery is exhausted. In this case, replace the battery with a new one.

Precautions concerning batteries

Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire.

ENGLISH

8

9