Connection
D
C
B
A
E
BREMOTE CONTROL SELECTOR
If the REMOTE CONTROL jack is connected to the A- H300mkIII, select ‘SYSTEM’. When operating the remote control unit provided with the
If the REMOTE CONTROL jack is NOT connected to the A- H300mkIII, select ‘SINGLE’.
CLINE OUT jack
Analog
Make sure to connect:
white plug q white jack (L: left channel) red plug q red jack (R: right channel)
DDIGITAL OUT terminal
Amplifier
CAUTION:
<Switch off the power to all equipment before making connections.
<Read the instructions of each component you intend to use with this unit.
<Be sure to insert each plug securely. To prevent hum and noise, avoid bundling the signal interconnection cables together with the AC power cord or speaker cables.
AREMOTE CONTROL jack
If you have TEAC
•When you tune in a station, the input selector of the A- H300mkIII is set to ‘TUNER’ automatically.
•You can use the system remote control unit
Connect the REMOTE CONTROL jack to the REMOTE CONTROL jack (A or B) of
Read the owner’s manual of
Note:
The remote control unit is not provided with this unit.
DAB’s digital audio signal is output from this terminal. If you want to record digitally, or decode the signal using an external digital decoder, connect to the digital input terminal of a digital recording device or a decoder using a
<When inserting the plug of the optical cable, the protective shutter of the terminal will open and you should hear it click into position when fully inserted. Be careful that you do not force the plug, because this could result in damage to the protective shutter, the cable, or the unit itself.
EAC Power Cord
After all other connections are complete, connect the plug to the AC wall socket.
Be sure to connect the power cord to an AC outlet which supplies the correct voltage.
Hold the power plug when plugging or unplugging the power cord.
3