Team Products PMD8131, PMD8129 Screwdriver Operation, Maintenance, SPECIFICATIONS for PMD8127

12V, 14.4V, 18V Cordless Drills

Your drill comes with an automatic braking function that quickly stops the chuck from turning when the trigger switch is released.

Your drill (models PMD8131 and PMD8133) has two speed ranges; low speed (position 1) (0-400 rpm) and high speed (position 2 ) (0-1100 rpm).

Screwdriver Operation

Place the point of the screwdriver bit into the head of the screw and apply slight pressure to the tool. Press the trigger switch slightly and then gradually increase the drill speed. Release the trigger switch as soon as the clutch engages.

Note: Starting the drill at too high of a speed can damage the drill bit or reduce the life of the bit.

Make sure that the driver bit is inserted straight in the screw head or the screw may become damaged or will not be inserted properly. When driving wood screws, pre-drill pilot holes into the surface to make driving easier.This will also prevent the wood from splitting.

Note: When drilling, the drill bit can become stuck. If this happens, a very high torque will be produced. Always take care to hold the drill firmly to prevent possible damage or injury.

Maintenance

Clean the Drill regularly. Before cleaning, remove the battery pack and any accessories (bits etc.).To clean, use ONLY a mild soap and damp cloth on the housing. Never immerse drill in any kind of fluid. Do not use any solvents or harsh abrasives on the drill housing as this may cause damage to the unit. Always keep the ventilation openings clear.

NOTE: All bearings in these tools are lubricated with a sufficient amount of high-grade lubricant for the life of the unit under normal operating conditions. No further lubrications required.

CAUTION: DO NOT keep the trigger switch pressed in with tape or any other permanent means or the circuit will not function properly. A malfunction may result, possibly causing overheating or damage to the unit.

Do not open the drill, battery or battery charger.There are no user serviceable parts. Opening the unit will void the warranty.

7

Owner’s Manual

TROUBLESHOOTING TIPS:

DRILL DOES NOT WORK?

• Recharge the battery

CHARGING INDICATOR LED NOT ILLUMINATED DURING RECHARGING?

•Check that battery pack is properly connected to the battery charger

•Check that the AC Adaptor is properly connected at both ends

SPECIFICATIONS for PMD8127

Voltage	12V
Speed 1	0-600RPM
Torque Settings	24 + Drill
Chuck Capacity	up to 3/8”
Charger Input	120V AC 60Hz
ChargingTime	Approx. 3 –8 Hours
BatteryType	Ni-Cad
SPECIFICATIONS for PMD8128
Voltage	14.4V
Speed 1	0-600RPM
Torque Settings	24 + Drill
Chuck Capacity	up to 3/8”
Charger Input	120V AC 60Hz
ChargingTime	Approx. 3 –8 Hours
BatteryType	Ni-Cad

8