Technicolor - Thomson 29870 Series manual Wall Mount Installation

WALL MOUNT INSTALLATION

1.Turn the handset hook 180º until it clicks into place. You need to do this so that the handset doesn’t fall out of the base.

2.Plug the coiled cord into the handset. Plug the other end into the jack on the side of the base.

3.Place the handset in the base.

4.Carefully turn the phone over. Detach the wall mount bracket from the two sets of top grooves by pressing the tabs in. Pull the bracket from the phone and turn it around so that it looks like the diagram below. Gently press the bracket into the two sets of bottom grooves until it snaps into place.

5.Plug the short line cord into the jack on the back of the base.

6.Feed the short line cord through the grooves provided so that the bottom of the phone is flat and ready to mount on the wall.

7.Connect the other end of the line cord into the wall phone jack.

8.Set the TONE/PULSE switch to TONE for touch-tone service, or PULSE for pulse (rotary) service. If you don’t know which type of service you have, check with the phone company.

9.Connect the small end of the power supply into the POWER 9V AC jack on the back of the answerer. Plug the other end into an AC power outlet. The unit beeps 3 times and is ready for setup or to answer calls with the default greeting and settings.

10.Slip the mounting holes of the base (on bottom of unit) over the wall plate posts and slide the base down until the phone is firmly in place.

+

_

ALL NEW

PLAY / STOP

1 2 3

4 5 6

7 8 9

* 0 #

CAUTION: Only use the Thomson 5-2434A power supply that was packed with this unit. Using other power supplies may damage the unit.

6