Owner’s Manual 13
Installation
ENGLISH
Connecting the PC
- To enjoy vivid picture and sound, connect a PC to the Monitor.
- Avoid keeping a fixed image on the monitor’s screen for a long period of time. The fixed image may become permanently imprint-
ed on the screen; use a screen saver when possible.
- Connect PC to the RGB INPUTor DVI INPUT port of the Monitor; change the resolution output of PC accordingly.
-There might be a noise according to some resolution, vertical pattern, contrast or brightness in PC mode. Then change the PC
mode into other resolution or change the refresh rate into other rate or adjust the brightness and contrast on the menu until the
picture is clean. If the refresh rate of the PC graphic card can not be changed, change the PC graphic card or consult it to the
manufacturer of the PC graphic card.
- The synchronization input form for Horizontal and Vertical frequencies is separate.
Setup Instructions to Connect a PC to your Monitor
- We recommend using 640x480, 60Hz for the PC mode, they provide the best picture quality.
- If the resolution of PC is over UXGA, there will be no picture on the Monitor.
-Connect the signal cable from the monitor output port of the PC to the RGB INPUTport of the Monitor or the signal cable from
the DVI output port of the PC to the DVI INPUTport on the Monitor.
- Connect the audio cable from the PC to the Audio input on the Monitor. (Audio cables are not included with the Monitor).
- If using a sound card, adjust PC sound as required.
- This monitor apply a VESAPlug and Play Solution. The monitor provides EDID data to the PC system with a DDC protocol. The
PC adjusts automatically to use this monitor.
- DDC protocol is preset for RGB (Analog RGB), DVI (DVI, Digital RGB) mode.
- If required, adjust the monitor settings for Plug and Play functionally.
-If graphic card on the PC does not output analog and digital RGB simultaneously, connect only one of both RGB INPUTor DVI
INPUTto display the PC on the monitor.
If graphic card on the PC does output analog and digital RGB simultaneously, set the monitor to either RGB or DVI; (the other
mode is set to Plug and Play automatically by the monitor.)
-DOS mode may not work depending on video card if using a DVI-I cable.
- To see a normal picture, match the VGAmode and DVI signal (640x480, 848x480, 852x480). (See page 14)
How to use
1. Turn on the PC and apply power to the Monitor.
2. Turn on the display by pressing the POWERbutton on the Monitor’s remote control.
3. Use the
av
or

pc

button on the remote control to select the RGBor DVI input source.
4. Set the resolution output of the PC to SXGAor under (1280 x 1024, 60Hz).
< Back panel of the Monitor >
( )
( )
R
( )
( )
L
RS-232C INPUT
(CONTROL/SERVICE)
EXTERNAL SPEAKER
AC INPUT
AUDIO INPUTRGB INPUTDVI INPUT