Microphone |
|
|
|
| 5 |
|
| 2 |
|
| 6 |
|
| 1 |
|
| 6 |
3 | 4 | 7 |
| ||
|
|
To attach the optional microphone (AJ MC700) to the camera proceed as follows:
a.Open the microphone holder by unscrewing the knurled screw(1) of the microphone support bracket
(2)on the viewfinder and open.
b.Slide the microphone into the split tube until the microphone shoulder reaches the mark (5) in the tube.
c.Place the tube with the microphone into the holder with the split facing upwards.
d.Ensure that the rubber supports at the back and front of the holder fit into the rims (6)around the tube.
e.Close the holder and tighten the knurled screw at the top.
f.Connect the microphone cable to audio connector
(3)(mic) on the right side of the camera.
g.Place the microphone cable into the top clip at the front of the camera and into clip (4) at the side of the camera.(Pull and twist clip (4) to open it.)
Other microphones with a diameter of 21mm can also be used, however, ensure that the phantom power and the sensitivity of the input that match that type of microphone are correctly selected in the camera systems menu. Refer to Section 6 for more information on selecting the audio inputs and controlling the audio level.
Note:
·When longer microphones are used, it is not necessary to place them in the split tube.
·For optimum operation, the microphone should be mounted as straight as possible.
·Don’t allow the wind hood to touch the holder (7) as this reduces the damping effect.
·By placing the split facing upwards, the microphone cable does not touch the holder thus avoiding mechanical
·The microphone can also be connected to the rear of the Triax adapter where a switch selects the input. Refer to Operator's Guide Triax adaptor for more information on connecting the microphone to the rear connector.
02.38.1 | User's Guide LDK 5302/60 - 2 Inch HDTV Viewfinder |
