AM1550 EN rev.1 10/29/01 2:17 PM Page 6
Before
you
Begin
EN Unpacking the system
Unpack your new mini audio system and locate all the accessories. You should have:
•one main unit (with 2 speakers);
•one remote control;
•one AM loop antenna;
•one FM wire antenna;
•one guarantee card;
•one user’s guide.
For Thomson model, you should also have;
•one audio cable;
•Thomson Multimedia Pack including MusicMatch Music Management software
Check for Moisture
Just as moisture can form on the inside of windows on a cold day, it can also form on the inside of your audio system causing it to malfunction.
If there is any moisture inside the system, the system may not operate properly. In this case, you are sug- gested to disconnect the power to the unit and wait for about 30 minutes for the moisture to evaporate.
Choosing System Location
It is recommended to follow these guidelines when setting up your system:
•Choose a solid, level surface. Don’t place on surfaces like carpet or foam rubber.
•Choose a location away from direct sunlight, radia- tor, air ducts and sources of heat.
•Avoid locations subject to moisture, mechanical vibration, shock or excessive dust.
•Ensure that the location is adequately ventilated, as it is essential to protect the unit from internal heat
| 10 cm |
10 cm | 10 cm |
Inserting Batteries into Remote Control
Open the battery compartment door on the back of the remote unit and insert correctly 2 AAA (LR03) bat- teries with + or - signs matching with indications.
To use the remote control, point it directly at the unit.
Cable Connections
Refer to the following for connections on the back panel:
1
3
62
5
4
SUBWOOFER
OUTPUT
4
1.AM Loop Antenna Connector
2.FM Antenna Jack
3.auxiliary Input Jacks
4.Subwoofer
5.Main Speaker Jacks
6.Optical Output
Power Connections
Plug the power supply cord into an AC power outlet.
Note: For the sake of safety, complete all cable con- nections before you plug for power.
2
