Technicolor - Thomson CS104 user service Getting Started, Unpacking Your System, Installation

Getting Started

Unpacking Your System

You should have:

•One main unit (with 2 speakers);

•One remote control;

•One user’s guide;

•One Thomson Warranty Card

Installation

To ensure sufficient ventilation, keep the spacing shown as below:

Front View	10cm
	MULTI FUNCTION LCD DISPLAY
		CD
	DIGITAL PLL SYNTHESIZED TUNER	TUNING
ON•ECO		VOLUME
IR SENSOR
		CONTROL
TIMER
10cm		10cm
	DIGITAL LOGIC DECK
		OPEN/
	PLAYBACK/ RECORD	CLOSE
Side View	10cm

5cm

Connecting the Speakers EN

When connecting the speakers, match the red wires to the red jacks and the black wires to the black jacks. Each speaker has a black and a red jack, one for positive and one for negative. The top two jacks are for the left speaker, while the bottom two jacks are for the right speaker.

RL

Speaker Wire Connection

Push Speaker terminal tab	Release tab to lock wire in
down to insert wire.	the terminal.

NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.

Using the Antenna

Before you use your audio system, you’ll want to make sure the FM antenna is positioned properly. The FM antenna is the coiled wire connected to the back of the unit. Uncoil it, making sure it is fully extended (you may even want to tape it to the wall behind the unit, if possible. The higher, the better.)

For better AM reception, move or rotate the unit.

2

CS104 EN 5 3/8/04, 1:46 PM