CS300 EN 11/20/02 10:19 AM Page 6
Getting Started
EN Unpacking the system:
You should have the following:
•one main unit (with 2 main speakers);
•one remote control;
•one user’s guide;
•AM loop antenna;
•FM wire antenna
•one Thomson warranty card
Back View
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 2 |
| 3 |
| 4 |
| 5 |
| 6 |
|
|
|
| 1 |
| |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1.Main Speaker Jacks
2.Line Out Connector
3.Aux In Connector
4.AM Antenna Jack
5.FM Antenna Jack
6.Optical Out
Using the Antenna
Before you use your audio system, you’ll want to make sure the FM antenna is positioned properly. Connect the FM antenna to FM ANT jack on the back of the unit. Uncoil it, making sure it is fully extended (you may even want to tape it to the wall behind the unit, if possible. The higher, the better.)
For AM reception, you need to connect the AM loop antenna. For better AM reception, rotate the AM loop antenna.
Connecting the Speakers
Each speaker has a black (negative) and a red (positive) jack. When connecting the speakers, match the red wires to the red jacks and the black wires to the black jacks.
Speaker Wire Connection
Push terminal tab down to | Release tab to lock wire in |
insert wire. | the terminal. |
NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.
Installation
To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:
Front View |
| 10 cm/ 4” |
10cm |
| 10 cm |
| / 4” | |
/ 4” | CS300 | |
|
| |
|
| Control panel |
Side View |
| 10 cm/ 4” |
5 cm |
|
|
/ 2” |
|
|
2
