Technicolor - Thomson CS600 user manual Getting Started

CS600 EN 5/17/05 2:08 PM Page 10

Getting Started

Getting Started

EN Unpacking the system

You should have the following:

•one main unit (with 2 main speakers);

•one remote control;

•one AM loop antenna;

•one user’s guide;

•one safety leaflet;

•Guarantee card

!

Warning:

Use of this product is for your personal use only. Unauthorized recording or duplication of copyrighted material may infringe upon the rights of third parties and may be contrary to copyright laws.

Note:

Make sure the tracks are encoded in mp3 or Windows Media formats and supported bitrates. Bitrates supported by the player:

mp3 – 32 to 320kbps wma – 48 to 160kbps

Back View

3 1

2

4

1.FM Antenna.

2.Main Speaker Jacks.

3.AM Loop antenna Jacks.

4.AUX IN

Using the FM and AM Antennas

Before you use your audio system, you’ll want to make sure both the FM and AM antennas are positioned properly. Uncoil the FM antenna at the back of the unit, making sure it is fully extended (you may even want to tape it to the wall behind the unit if possible. The higher the better.) You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.

Connecting the Speakers

Each speaker has a black (negative) and a red (positive) jack. When connecting the speakers, match the red wires to the red jacks and the black wires to the black jacks.

Speaker Wire Connection

Push Speaker terminal tab	Release tab to lock wire in
down to insert wire.	the terminal.

NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.

InstallationEN

To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:

Front View	10 cm
10 cm	10 cm

Side View
	10 cm

5 cm

3 4