DPL680 EN 4/8/04 4:01 PM Page 25
Advanced Sound Control
Fine Setting of the Components
The receiver can be directly turned on by pressing the
DVD•6CH / SAT•CABLE / TV / CD•TAPE / VCR / TUNER buttons on the remote control, which also selects the best surround sound mode. The default surround modes for different components are listed in the table below. If you decide to change the surround mode, you can press the SURROUND button repeatedly to toggle among the different surround mode choices and select the one you want.
DOLBY PLII MUSIC => DOLBY PL EMULATION => 3 STEREO => ARENA => JAZZ CLUB => THEATER =>
STADIUM => DISCO => STEREO => DOLBY PLII MOVIE
The receiver will keep the last selection in memory.
Source/ | If Digital Input (optical | If Analog Input | |
Input | or coaxial) is selected | is selected | |
|
|
| |
DVD | Dolby Digital | DOLBY PLII MOVIE | |
VCR | N/A | DOLBY PLII MOVIE | |
SAT | Dolby Digital | DOLBY PLII MOVIE | |
CD | STEREO | STEREO | |
TAPE | N/A | STEREO | |
TV | Dolby Digital | DOLBY PLII MOVIE | |
TUNER | N/A | STEREO | |
|
|
|
NOTE
If linear PCM source (CD), format will be Dolby Prologic even with Digital Input.
Digital Input
Select this setting to play digital signals from a DVD, CD, | EN | |
LD player, SAT or TV. |
| |
|
|
|
SOURCE | DEFAULT INPUT (as seen on display) |
|
DVD | Analog (DVD/ ANL) |
|
VCR | Analog (VCR/ ANL) |
|
SAT | Analog (SAT/ ANL) |
|
CD | Analog (CD/ ANL) |
|
TAPE | Analog (TAPE/ ANL) |
|
TV | Analog (TV / ANL) |
|
FM/AM |
| |
|
|
|
NOTE
Digital input is only available for DVD, SAT, CD and TV
Analog Input
Select this setting to play analog signals from a cassette deck, VCR or turntable.
SOURCE | AVAILABLE INPUT |
| |
DVD | Analog / Optical 1 / Optical 2 | / Coaxial | |
VCR | Analog / |
|
|
SAT | Analog / Optical 1 / Optical 2 | / Coaxial | |
CD | Analog / Optical 1 | / Optical 2 | / Coaxial |
TAPE | Analog / |
|
|
TV | Analog / Optical 1 | / Optical 2 | / - |
|
|
|
|
Input Signal Setting
The receiver defaults to the most convenient settings for your easiest use (see table).
If your connection is different from the default setting,
1.Select the source
2.Press the SETUP button to show setup options.
3.Press the Left or Right adjustment buttons until ANALOG is displayed.
4.Press the Up or Down arrow buttons to select among optical/ coaxial/ analog to match your connection. Your selection will be stored automatically.
The selected source and input source will be displayed on the display as long as they are active, except for some temporary change of display (e.g. adjusting volume).
21
