DPL680 EN 4/8/04 4:01 PM Page 26
Advance Sound Control
Fine Setting of the Speakers
All the basic settings have already been
Also, to make the surround sound more effective and suit the acoustic conditions in your listening room, you may need to delay the signal coming from some of the speakers. Channel delay compensates for center or surround speakers that are closer to the listening position than the front speakers. You can make use of the SETUP button to adjust the speakers’ relative loudness.
Testing Speaker Loudness
You can listen to the loudness of the individual speakers by doing the following:
1. Press and hold LEVEL on the remote control.
A short noise will be heard in the speakers one by one. The speaker having the noise at that moment will be shown in the display.
2.To adjust the volume level of the test tone, turn the VOLUME knob or press the VOL Up or DOWN buttons on the remote control to adjust the master volume (if necessary).
Adjust Individual Speaker Volume
1.To adjust individual speaker volume level, press the LEVEL key on the remote control.
2.Continue to press the LEVEL button on the remote control to select the channel to be adjusted, then press the Up or Down buttons to adjust
the level.
You can adjust the master volume level by turning the VOLUME knob or press the VOL UP or DOWN buttons on the remote control.
Advanced Setting
Factory defaulted Advance setting indication from VFD
The receiver has defaulted the following distances:
Front | Center | Front | |
Left | Right | ||
| |||
|
| Cch | |
Lch |
| Rch | |
L/S |
| R/S |
PRESET
VOLUME
Press LEVEL again and press the Up or Down buttons to adjust the individual channel noise level.
Rear |
| Rear |
Left |
| Right |
Front speakers (FRNT) | 5m |
Center speaker (CNTR) | 5m |
Rear speaker (SURR) | 3m |
22
