Technicolor - Thomson DPL680 manual Protect your Components from, Overheating, Using Headphones

Models: DPL680

1 28
Download 28 pages 17.41 Kb
Page 6
Image 6
Inserting Batteries into Remote Control

DPL680 EN 4/8/04 4:00 PM Page 7

Getting Started

Inserting Batteries into Remote Control

Install batteries as follows:

1.Remove the battery compartment door by applying thumb pressure on battery door and then lift the door out and off the cabinet.

2.Insert 2 “AAA” (R03) batteries into the battery compartment according to the + and - signs in the compartment and replace the compartment door.

3.To use the remote control, point it directly at your receiver.

Set up and Maintenance of the Receiver

Provide spaces for sufficient ventilation as indicated:

Protect your Components from

 

Overheating

EN

Do not block ventilation holes in any component. Arrange the components so that air can circulate freely.

Do not stack components directly on top of each other.

Do not place the unit near other components that generate heat such as heating vents.

Allow adequate ventilation when placing your components in a stand.

Place an amplifier near the top shelf of the stand so heated air rising from it will not affect other components. If you have a satellite receiver, you should place it on the top shelf.

 

10 cm/4"

 

10 cm/

Front View

10 cm/

4"

 

4"

 

10 cm/4"

 

5 cm/

 

 

2"

Side View

 

Do not connect to the AC power cords until all connections are completed.

Do not use your set immediately after transferring it from a cold place to a warm place: there is risk of condensation.

Do not expose your set to water and excessively high temperatures.

After having disconnected your set, clean the case with a soft cloth, or with a slightly damp leather chamois. Never use strong solvents.

Using Headphones

To listen privately through your audio system, use the PHONES jack on the receiver. However, make sure you turn down the volume before you put on the headphones. Increase the volume to the desired level after headphones are in place.

Once headphones are connected, “HEADPHONE DOWN MIX 2 CHANNEL” will scroll on display. This feature automatically converts multi-channel speaker outputs to 2 channel stereo for your listening pleasure.

Hearing Comfort & Well-Being

Do not play your headset at a high volume. Hearing experts advise against continuous extended play.

If you experience a ringing in your ears, reduce volume or discontinue use.

3

Page 6
Image 6
Technicolor - Thomson DPL680 Protect your Components from, Overheating, Using Headphones, Hearing Comfort & Well-Being