Satellite set-up
16
10.Deactivating the programming of the satellite or cable receiver
Yes is selected to deactivate the programmer. In
that case, all your satellite recordings will have to
be programmed from your satellite or cable
receiver (this is the recommended setting). Leave
Yes selected and press
ok
.
11.IR controller connection
• Follow on-screen instructions and press
ok
.
12.Enter the receiver code
• Now key in your receiver’s satellite code
number (refer to the table on the next page), then
press
ok
to validate. If the make or model of
your satellite or cable receiver is not shown, try
other numbers in the list displayed. If
unsuccessful, contact your retailer.
13.Press ok to start the test
ðThe DMR sends a signal to your satellite receiver via the infrared controller cell. A
configuration menu will appear as the satellite receiver positions itself on channel 12
(check that channel number 12 appears on the display panel of the satellite receiver,
sometimes fleetingly, and even if no picture is visible on the TVscreen).
If the satellite receiver is not on channel 12, select
No with the …or †keys and press
ok
.
ðYour DMR sends a new command to the
satellite receiver. (Several tests are possible,
depending on the make of your satellite
receiver).
If the satellite receiver goes on to channel 12,
select Yes with the …or †keys and press
ok
. If
unsuccessful, repeat the settings, starting at step
11, but with the satellite receiver positioned on
channel 0instead of 2.
ðAchannel sorting window will appear. The picture of the selected channel is shown in the
background. Refer to page 11 to sort the stored channels or set the time on your DMR if
necessary.
ðYour DMR is now ready to control your satellite receiver to program
recordings.Your DMR asks you to display channel 2on the
satellite receiver. However, with some receivers, it is
preferable to display channel 0.
DTH7000-EN 23/08/02 10:24 Page 16