6.Place 1 sealing washer (rubber side towards vehicle floor) and 1 large fender washer over each of the floor bolts and attach the floor nuts. In addition to the sealing washer, it may be desirable to place a small circle of silicon sealer around the hole under the vehicle before installing the washers and nut, to further prevent moisture from getting into the vehicle.
7.Tighten the floor nuts down securely. Have the 2nd person inside the vehicle hold the floor bolts securely with the
8.Press the latch of the door at the rear of the console to the right and open the door. Then set the console on the mounting plate, with the slot of the console base pointing to the tongue end of the mounting plate, and the two holes in the rear of the console pointing to the two holes in the upright end of the mounting plate.
9.Apply a firm push forward to mate the console base and the floor mounting plate, with the tongue of the mounting plate projecting into the slot of the console base.
10.Place the spring washer on the 2 console bolts.
11.Place the console bolts through the mounting plate and into the two holes at the rear of the console base.
12.Tighten the console base bolts with a Phillips screwdriver.
G.Powering the unit (Refer to Figure 3)
NOTE: Have all the wires, such as the power cord, AV cables and external antenna cable, or CATV cable, pass through the two notches at the bottom of the door.
Plug the cigarette lighter cord into the
NOTE: If the unit draws in excess of 10 Amperes, the power supply will deactivate and turn off the unit.
6
