Technicolor - Thomson MS2200 manual Remote Control, General Controls, Next, Prev

MS2200 EN 11/17/03 1:59 PM Page 9

General Controls

Remote Control

TUNER	SOURCE	TAPE
CD		AUX

	E	Q	B.B	OOST
ON•ECO				DEMO/DIMMER
				CD INFO
		VOL
PREV				N
				T
				EX
RE
V				FWD
		VOL
RECORD				STOP
REPEAT•RDS				PTY
FM ST.		DISC SKIP		INTRO•CT
DN•PRESET•UP				SLEEP

Battery Size:

“AAA” or “UM-4” or “R03”

EN

ON•ECO — Press and hold in STANDBY mode to enter ECO (power saving, without clock display) mode.

CD — Selects CD player. TUNER — Selects radio tuner. TAPE — Selects tape player. AUX — Selects external input. EQ — Selects equalizer presets. B.BOOST — Turns on or off Bass Boost.

DIMMER / DEMO / CD INFO — Turns the feature demonstration on or off; adjusts display brightness; selects among displaying disc details. VOL+ or VOL- — Increases / decreases volume.

PLAY/PAUSE — Plays and Pauses the CD or tape.

NEXT	/ FWD	— In CD mode - Increments CD track and
setting options; searches forward through CD;
In Tuner mode - tunes up radio frequency;
In Tape mode - fast forwards tape.
PREV	/REV	— In CD mode - Decrements CD track and

setting options; searches backward through CD; In Tuner mode - tunes down radio frequency; In Tape mode - rewinds tape.

RECORD — Starts tape recording. STOP — Stops CD and tape playback.

REPEAT•RDS — Repeats a track, CD, or all CDs. When the radio is active, displays RDS information.

MUTE — Mutes volume.

/PTY — Turns on/off random listening, selects search by program type in tune mode.

FM ST. — Toggles between FM stereo and mono. DISC SKIP — Skips to next CD.

INTRO•CT — Turns INTRO mode on or off to play the first 10 seconds of each track, shows RDS time.

PRESET UP/DOWN — Selects next/ previous preset station.

SLEEP — Press to select the time interval in minutes before the unit turns off.

Installing Batteries

The remote control must be inserted with 2 “AAA” or “R3” or “UM 4” batteries prior to use. Follow the steps below to ensure correct installation.

1.Open the battery compartment door (located at the back of the remote control) by sliding the cover out.

2.Before inserting the batteries, observe the polarities (that is,

+ and -) of the battery then relate the polarities to the engraved diagram inside the battery compartment. Now insert the batteries.

3.After installation of the batteries, place the lit to cover the batteries. Lightly push it closed with a snap.

4