Technics SL-P9066, SL-PD967 Turn the knob in the ..... or, + direction, To fine-tune the pitch

,,ii i iiiiii i!!i!i!i! iii!i iiiiiiiii!i¸ i!i'ii!ili! i i

i-_--1[Start recording on the tape deck and

then immediately:]

_._ Press I_.

When the last track set for recording on side A is finished, the changer will enter the pause mode. Set the tape to the position

from which recording will begin on side B, and then perform step 4 once again.

When all the programmed tracks on the specified disc finish play-

ing, the changer will automatically stop. The edit guide mode will

be canceled at the same time.

To enter a desired recording time other than 46,

60 or 90 minutes:

1	Select	"C---"	in	step 3.
2	Enter	the total		recording	time in minutes	(1-99) using the
	numeric	buttons.

For example:

To use 52-minute tape, press 5 then 2.

You can also specify the tape length pressing the SKIP button.

Press eitherl_l_l or I_IN from each step C-46, C-60, C-90 or C---.

For example:

To use 52-minute tape, select C-46 and then press and hold I_1 until the display shows "52".

The maximum allowable playing time for editing is 99 minutes.

To stop recording

button on the tape deck.

Press • and then press the stop

ir,,t_,'JI

Depending on the disc, a little of the beginning of the next track

may be recorded onto the end of the track.

The playback pitch can be changed as desired within a range of +12.5%. (The tempo and the pitch of the sound will change simultaneously.)

12,

/_........ 0_.LL.L Press OF FION. ................

OFF/ON -"The pitch control indicator on this unit will illuminate.

_ Turn the knob in the ..... or

( O ) "+'' direction.

-: Pitch decreases

+: Pitch increases

The pitch will change while the knob is being

held, and the changed values will show on the display.

\t /

DISCo

(•'-,),,, •,-,)? / + c i

Pitch display

If the knob is released, the pitch will stop

changing, and after approximately 2 seconds the pitch display will change back to the time display.

Pitch changing steps:

The +5.9% position is a half tone-sharp

(;).

The -5.6% position is a half tone-flat ( b ).

To fine-tune the pitch

Turn the knob and then immediately turn it back to the original

position In this case, the pitch will change by 01% only.

To play in 0% standard pitch

Press OFF/ON so that the pitch control indicator will switch off.

Even after the pitch control indicator has been switched off, the pitch setting will remain in memory.

For your reference:

•The pitch can be adjusted by turning the knob even if the pitch

control indicator is switched off The playback sound will not change if this is done. To play back at the setting pitch, press

OFF/ON to make the pitch control indicator illuminate.

•While changing the pitch, the time display will show the

playback position only. This will not match the actual playback time.

•The pitch value and the on/off setting of the pitch control will re- main stored in the memory even after the unit is switched off. However, if the power cord is unplugged or the power supply is

otherwise interrupted for an extended length of time, the memory will be erased

12'