Technika 320Gb T835 user manual Installation

Menu Lock

In menu lock you can set locking for All Menus, or the Installation Menu to restrict access to these menu’s. If the menu lock is disabled, there will be free access to the menu system. Use “”/“” buttons to go to Menu Lock option. Use “”/“” buttons to choose Menu Lock Mode.

DISABLED : All menus are unlocked.

ALL MENUS : All Menus are accessible only with the correct lock key.So the user can’t add, delete, rename, channels, can’t set timers.

INSTALLATION MENU : Installation menu is locked.So the user can’t add channels. Changes will be updated after exiting ‘Configuration Menu’.

Set Pin

The PIN code of the unit changed. Use “”/“” buttons to go to “Set PIN” option. Press OK to display the “Set PIN” window. Use NUMERIC buttons to enter new pin number you will need to input your new pin a second time for verification purposes. If Both pin numbers are four digits long and the same, the pin will be changed. The factory default pin number is 0000, if you change the pin number make sure you write it down and keep it safe.

Low Power

If you select YES, low power mode will be activated. In low power mode the power consumption is less then 1 W (in standby). The front display will show no time information (in standby). If low power mode is deactivated, all functions will be reactivated.

Language

In this menu the user can adjust the preferred language. Language is changed by pressing OK key.

Menu: shows the language of the system

Preferred

These settings will be used if available. Otherwise the current settings will be used.

English

•Audio: by pressing “”/“” keys change the audio language.

•Subtitle: alter the subtitle language with “”/“” keys. The chosen language will be seen in subtitles.

•Guide: by pressing “”/“” keys change the guide language.

Current

•Audio: if audio language is supported change the audio language by pressing “”/“” keys

•Subtitle: if subtitle is backed up alter the subtitle language with “”/“” keys. The chosen language will be seen in subtitles.

Installation

Automatic Channel Scan / Retune

Automatic channel scan is activated by selecting OK when the line is highlighted. A pop-up menu appears on the screen, select “YES” the automatic scan begins. All the multiplexes are searched and a channel table is created automatically. All channels found are stored in a sorted form with respect to their channel numbers. Selecting “NO” will cancel the operation.

Manual Channel Scan

In manual search the number of the multiplex is entered manually and only that multiplex is searched for the channels. In manual and auto search, any existing channel in the database is not re-stored to avoid redundant duplicates of that channel. To start the scan enter the channel number manually and press OK.

First Time Installation

Use this option to load default settings, which had been set at the factory. To install factory settings, highlight ‘First Time Installation’ menu and press OK key, then you will be asked to confirm deleting all channels and settings. Selecting YES and pressing OK will delete the channel table. Selecting “NO” and pressing OK will cancel the operation.

Message

When the box receives no signal (e.g. the antenna cable is disconnected), “NO

SIGNAL” message is seen on the screen.

t

- 17 -