GETTING STARTED

FM AERIAL

Before using your clock radio for FM reception, unwrap and fully extend the aerial wire. You may need to adjust the position of the aerial wire for maximum signal strength.

CONNECTING AC MAINS POWER

Before connecting the power, check that the mains voltage on the rating plate of the AC adaptor is the same as the voltage in your area.

•Plug the DC cord from the AC adaptor into the DC jack on the back of the unit.

•Plug the AC adaptor into the wall socket and switch the mains power on.

The unit is now ready for use.

NOTE:- The AC adaptor may become warm during operation - this is normal.

POWER CONTROL

STANDBY CONTROL

To turn the radio on:

•Press the /ALARM RESET button on the top panel. The unit will switch on and the iPod, FM or AUX function indicator will light to show the selected audio source.

To set the radio to Standby:

•Press the /ALARM RESET button on the top panel. The unit will set to Standby. All function indicators will switch off.

TIME AND DATE DISPLAYS

SETTING THE TIME AND DATE

When first switched on, the clock and date displays on your radio will not be set.

Choosing 12 or 24 hour clock time display:

•At any time you can press the 12/24 hr. button on the back panel to switch the clock display between 12 or 24 hour time display.

The clock and alarm displays will toggle between 12 hour (with AM and PM indicator) and 24 hour modes.

NOTE: changing between 12 and 24 hour display will not affect the clock or alarm settings.

To set the clock time:

•Press the TIME button briefly. The hours digit will flash.

•Press the }/SET+ or {/SET- button to set the correct hour.

•Press the /,/ENTER button to confirm this setting. The minutes digits will flash.

•Press the }/SET+ or {/SET- button to set the correct minutes.

•Press the /,/ENTER button to confirm this setting. The clock is now set.

To set the date:

•Press and hold the TIME button.

The year digits will flash.

•Press the }/SET+ or {/SET- button to set the correct year.

•Press the /,/ENTER button to confirm this setting. The month (left) digits will flash.

•Press the }/SET+ or {/SET- button to set the correct month.

•Press the /,/ENTER button to confirm this setting. The date (right) digits will flash.

•Press the }/SET+ or {/SET- button to set the correct date.

•Press the /,/ENTER button to confirm this setting. The date is now set.

SETTING THE TIME AND DATE USING THE TECHNIKA iPhone APPLICATION

The time, date and alarm settings for your clock radio can also be set via a Technika application for iPhone or iPod touch.

Once this application has been installed, you can set time, date and alarm settings into the application. When you next dock your iPhone to the clock radio, these settings will synchronise.

For more details of installing and using the Technika application, refer to the ‘Advanced Operation’ section on page 13.

7