FM RADIO AERIAL
Before using your unit for FM reception, unwrap and fully extend the aerial wire. You may need to adjust the position of the aerial wire for maximum signal strength.
AM RADIO LOOP AERIAL
If you plan to listen to AM radio stations, you will need to assemble and connect the AM loop aerial.
Assembling the AM aerial:
1. The aerial | stand is | Stand |
| ||
| located inside the | A | |
| loop aerial. |
|
|
3.Raise the loop to a vertical position and
tuck the clips on the B loop into the slots in the base.4.When correctly assembled the loop aerial will stand as shown.CD
ClipsSlotsConnecting the AM aerial:
The bare wire ends from the AM aerial connect to the two terminals on the back panel marked AM ANTENNA.
•Place the AM aerial in a convenient location, standing on its base.•Hold the latch down andinsertoneofthebarewire ends from the AM aerial into an AM ANTENNA terminal (polarity is not important).
• Release the latch to secure the wire.•Connect the second aerial wire to the other terminal in the same way.
Placement of the AM aerial:
The AM aerial is very sensitive to position. If possible, position it away from electronic equipment and metal objects. It may be necessary to adjust or rotate the aerial for the best signal.
BACKUP BATTERIES
Backup batteries may be fitted to your photo frame. With backup batteries fitted, the unit will retain time and alarm settings.
The backup battery compartment is located on the back of the unit.To fit a backup battery:
1.Referring to the drawing, locate the battery compartment and press the catch down to open the door.
Press the
catch downFit 2 x AAAbatteries2.Lift out the battery cover.3.Fit 2 x AAA batteries, observing polarity as shown.4.Replace the battery cover.Battery disposal:
Dispose of used batteries with regard to the recycling regulations in your area. Do NOT short circuit batteries or throw them into water, the general rubbish or in a fire.
Weak batteries can leak and damage the unit. Replace them in good time!5