PREPARATION FOR USE

PROTECTIVE FILM

Some of the panels on this unit are protected by plastic film for protection in shipping. Remove all of this film and any tape securing it before use.

NOTE: Damage may result if film or tape is left in place on the sliding front panel and power is connected to the unit.

PLACEMENT

Placement on a table or shelf:

Place the unit on a sturdy table or shelf where it cannot get knocked over and where there is a clear line of sight to the remote handset.

Make sure that there is a clearance of 10cm (4 inches) above the unit for ventilation.

Optional wall-mounting:

The MC-121IDAB system has back panel fixings for optional wall-mounting.

If you plan to wall-mount the system, you will need to fix two screws into the wall.

Before fixing the screws, plan the location carefully, ensuring that mains power is accessible.

Once you have planned the location, fix two screws (not supplied) into the wall to support the main unit, spaced by 240mm. Before mounting the screws, check the fit of the heads in the back panel keyhole slots to ensure that the screw heads will not pull out of the slots.

240 mm

Use a spirit level to ensure that the screws will be level and check that the unit will be fixed at the height you require. When you have mounted the screws, mount the unit carefully onto the screw heads. Check that the mounting is secure before use.

NOTE:- Most walls will require the use of wall-plugs when mounting the fixing screws. If you are in any doubt concerning the type of fixing required or the security of wall-mountings, consult a building professional.

Important notes for wall-mounting:

•Tesco accepts no liability for damages caused by incorrect assembly, installation or improper use.

•Ensure that the wall has sufficient strength to hold the weight of the system.

•If there is any doubt regarding the condition or the load bearing of the wall, please consult a specialist from the building trade.

•The wall fixings used must be suitable for the type of wall (materials, thickness, condition), so that the maximum load bearing of the wall can be guaranteed.

•Ensure that no electrical cables, water pipes or gas pipes are located within the wall.

•Before mounting, check the location of the nearest mains socket.•Wear safety goggles when drilling.•Keep small parts out of reach from children.

3