GETTING STARTED

DAB/FM RADIO AERIAL

Before using your radio for DAB or FM reception, unwrap and fully extend the aerial wire. You may need to adjust the position of the aerial wire for maximum signal strength.

CONNECTING POWER

•Check that the mains voltage marked on the rating plate on the back of the unit is the same as the voltage in your area.

•Remove any protective packing from the mains plug pins.•Plug the mains plug into the wall socket and switch the mains power on.

MAINS POWER SWITCH

There is a mains power switch located under the unit. Check that this is set to the ON position.

UNDERSIDE VIEWMains power switch Power cable

In normal use this may be left in the ON position. When the unit is to be unattended for an extended period (for example, holidays) set the mains power switch to the OFF position or disconnect the system from the mains.

SETTING THE CLOCK

Automatic clock setting:

The clock time will set automatically when a DAB station is first tuned.

Manual clock setting:

The clock can also be set manually if you live in an area where it is not possible to receive DAB broadcasts.

•Check that the system is set to Standby.
•Press and hold the ID3/MEM./C ADJ. button. The hours digits will flash.
•Press the }or {button to set the hour digits.•Press the ID3/MEM./C ADJ. button.The minutes digits will flash.•Press the }or {button to set the minutes digits.

•Press the ID3/MEM./C ADJ. button.

The clock time will be set and the unit will return to Standby mode.NOTE: When a DAB station is tuned, the clock will always be set automatically.
STANDBY CONTROL

STANDBY CONTROL

To turn the system on:

•Press the STANDBY/ON button.The display will light and the system will set to play the last function used.

To turn the system off:

•Press the STANDBY/ON button.

The system will switch off and the display light will dim. The clock will continue to run whilst mains power is connected.

ADJUSTING THE VOLUME

VOLUME CONTROL

To increase the volume:

•Press the VOLUME + button.

To decrease the volume:

•Press the VOLUME - button.

The volume level will be displayed on a scale from 0 to MAX (40).

MUTE

You can use the Mute function to instantly set the volume to minimum.

To mute the volume:

•Press the MUTE button on the remote control to set mute at any time.•Press the MUTE button again to restore the volume to its previous setting.

6