Tefal BL1261KR manual Cleaning, Ingredients Quantities Max Recommended speeds Accessory

SM_BLENDER_MINI-MULTI_8080013800_Mise en page 1 04/07/14 13:45 Page4

Recommendations:

-Do not operate the appliance more than one minute continuously.

•To add ingredients while the blender is in use, insert them through the feeder hole in the lid

(B).

•Cut the ingredients into small pieces (approx. 15mm x 15mm) before putting them in the blender jug (C). Do not process a large quantity of ingredients at the same time.

CAUTION: If ingredients remain stuck to the blades, unplug the appliance and remove them with a spatula.

USING THE CHOPPER AND GRINDER ACCESSORIES (H or I) (depending on model)

The chopper accessory (I) allows you to chop ingredients such as meat (up to 80g cut into pieces), onions, garlic, ginger…

The grinder accessory (H) allows you:

-to grind coffee beans (up to 80g)

-to grind or chop various spices (chilies), rice, dried fruits and nuts such as hazelnuts, almonds.

CAUTION: Do not handle the accessory blade (H2 or I2) as they are very sharp and may cause injury.

1.Cut the ingredients into small pieces (approx. 15mm x 15mm). Place them into the chopper or grinder lid (H1 or I1). Refer to the table below for the maximum quantities to be used.

Ingredients	Quantities (Max)	Recommended speeds	Accessory
Meat (cut into pieces)	80g	15s on V2	I
Spices (chilies, pepper…)	50g	15s on V2	H
Coffee beans, rice	20-80g	30s on V2	H
Onions	20-100g	15s on V2	I
Garlic	20-100g	15s on V2	I

2.Fit the chopper or grinder blade unit (H2 or I2) onto the chopper or grinder lid (H1 or I1). Lock the blade unit by turning it clockwise (Fig. 4).

3.Turn the assembled chopper or grinder accessory upward. Place the chopper or grinder accessory onto the motor unit (G) and lock it (Fig. 5).

4.Plug in the appliance and switch it on by pressing the low-speed or high-speed button (E or F).

CLEANING

• Unplug the blender and remove all the

• accessories.

Handle the blades (H2 or I2) with care as they

• are very sharp.

Wipe the motor unit (G) down with a damp

• cloth. Dry carefully.

Never plunge the motor unit (G) into running water.

The chopper or grinder will not operate unless the blade unit has been correctly fitted.

5.Hold the accessory firmly with both bands during operation. Do not operate the accessory for more than 30 seconds at a time.

6.You can store the preparation in the fridge by removing the chopper or grinder blade unit, and covering the lid with the seal (J).

•To make cleaning easier, always wash the removable parts in warm water and washing

•up liquid immediately after use.

The blender jug (C), the lid (B), measuring cap

(A) and the accessories (H1, I1 & J) may be cleaned in the dishwasher in the upper tray, only using the “ECO” or “SLIGHTLY SOILED” programme.

4