3- CARING FOR YOUR IRON

ENG

BE CAREFUL ! Unplug your iron and let it cool down before cleaning it.

•CLEANING THE ANTI-CALC VALVE (Once a month) :

-Unplug your iron and empty the water tank.

-To remove the anti-calc valve, pull it up using the tabs located on each side (P).

NEVER TOUCH THE END OF THE VALVE.

-Soak the valve in a cup of white vinegar or plain lemon juice for 4 hours (Q).

-Rinse the valve under running water.

-Replace the anti-calc valve.

THE IRON WILL NOT FUNCTION WITHOUT THE ANTI-CALC VALVE.•SELF-CLEANING :

In order to extend the life of your iron, use the Self-Cleaning function once a month.

- Fill the tank of your iron with untreated tap water. Stand the iron on it’s heel with the thermostat set to max and heat it up. - When the thermostat light goes out, unplug the iron and hold it in a horizontal position, over a sink.

-Remove the anti-calc valve.

-Shake the iron gently, over the sink, until some of the water in the water tank (with the impurities) has flowed out through the soleplate.

-At the end of the operation, push the anti-calc valve back into position.

-Unplug the iron, and when the soleplate is just warm, wipe it with a soft cloth.

Recommendations :

the self-cleaning function helps to slow down the scaling up of your iron.

•CLEANING THE SOLEPLATE :

- While the soleplate is still just warm, clean it by rubbing it with a moist non-metallic pad.

4- STORING YOUR IRON

-Unplug the iron and wait for the soleplate to cool down.

-Empty the water tank and set the steam control to DRY. A little water may remain in the tank.

-Wind the cord around the heel at the back of the iron.

-Store the iron on its heel.

FOR YOUR SAFETY

•Read these instructions carefully before using your appliance for the first time :Tefal cannot be held reponsible for any use contrary to the instructions.

•Warning ! The voltage of your electrical installation must correspond to that of the iron (220V-240V). Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee.

•This iron must always be plugged into an earthed socket. If using a mains extension lead, ensure that it is correctly rated (10A), with an earth.

•If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Centre to avoid any danger.

•Never immerse your iron in water !

•The appliance must be unplugged before filling or emptying the water tank.

•

If it is dropped or it falls to the floor, the iron must not be used if there is any visible sign of damage or if it leaks.

•

If the appliance falls, have it checked by a professional before using it again; unseen damage may be dangerous for your security.

•The soleplate may be very hot :

-Never touch it.

-Always let it cool off before putting it away.

-Never leave your iron unattended when it is plugged in or while the soleplate is still hot.

-Always keep your iron out of the reach of children.

-Be careful of hot steam especially when ironing close to the edge of the ironing board.

•Your iron must be placed on a flat,stable, heat-resistant surface.

•When placing the iron on its stand, ensure that the surface on which the stand is placed is stable.

NEVER DISMANTLE YOUR IRON ; ALWAYS CONTACT AN APPROVED SERVICE CENTRE.

•This product has been designed for domestic use only.Any professional use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.