![](/images/new-backgrounds/1151771/1517717x1.webp)
2- DRY IRONING
-Choose your ironing program.
-Set the steam control to DRY (see diagram A).
-You may start ironing when the thermostat light goes out.
3- CARING FOR YOUR IRON
BE CAREFUL ! Unplug your iron and let it cool down before cleaning it.
•CLEANING THE ANTI-CALC VALVE (Once per month) :
- Unplug your iron and empty the water tank.
- To remove the
press the release button (P) and pull the valve upwards.
NEVER TOUCH THE END OF THE VALVE.
P
-Soak the valve in a cup of white spirit vinegar or plain lemon juice for 4 hours (Q).
- Rinse the valve under running water. - Replace the
Q
THE IRON WILL NOT FUNCTION WITHOUT THE
•
In order to extend the life of your iron, use the
-Allow your iron to heat up with the tank full and standing on its heel (on program 8).
-When the thermostat light goes out, unplug the iron and hold it in a horizontal position, over a sink.
-Remove the
-Shake the iron gently, over the sink, until some of the water in the water tank (with the impurities) has flowed out through the soleplate.
-At the end of the operation, push the
-Turn the iron back on for 2 minutes, setting it on its heel, to dry the soleplate.
-Unplug the iron, and when the soleplate is just warm, wipe it with a soft cloth.
Recommendations :
the
•CLEANING THE SOLEPLATE :
-While the soleplate is still just warm, clean it by rubbing it with a moist
4- STORING YOUR IRON
-Unplug the iron and wait for the soleplate to cool down.
-Empty the water tank and set the steam control to DRY. A little water may remain in the tank.
-Wind the cord not too tightly around the heel at the back of the iron.
-Store the iron on its heel.