Cleaning and maintenance
During cleaning and maintenance work, make sure the safety instructions set out on page 10 are complied with.
Cleaning the hood body
•If your kitchen hood is made from stainless steel, use proprietary cleaners mentioned in the product instructions.
•Never use metallic scourers, nor abrasive or corrosive products.
•Dry the kitchen hood using a cloth that does not produce fibres.
Cleaning the metal filters
To remove the filters from their fittings, press lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking them in hot water with neutral detergent until the fat dissolves and then rinsing them under the tap or using special
Cleaning in a dishwasher may damage the metallic surface (blackening it), although this will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit them onto the kitchen hood.
Changing light bulbs
Proceed as follows:
•Unscrew the lamp cap trimming cover.
•Change the broken/ burnt out lamp. Maximum lamp power is 20 W
•Screw in the lamp cap trimming cover.
ENG
_________________________________________________________
Problem solving
Proceed with the following checks before calling the Technical Service:
Sizes and specifications
See page 30.
TEKA INDUSTRIAL S.A. reserves the right to make changes and corrections to its products as it deems necessary, without altering their basic characteristics.
12
