Teka HW80-1401, HW70-1201, HW70-1401S manual Inlet Hose, Hose-sets should not be reused Drain hose

Before use
	07

Inlet Hose

1.Connect the nut on the inlet hose to the connector on the water valve.

2. Apply inlet hose to a water tap with cold, fresh water.

Note: Use the hose-set supplied with the appliance. Old	1.	2.
hose-sets should not be reused.

Drain hose
1. Use the drain hose bracket to keep the end of the drain hose retained		0cm
and prevent the outflow of water. Don't extend the length of the drain
hose; if an extended hose is required, please consult a serviceman.	1.	- 1 0
2. The height of the drainage outlet must be 80-100 cm. Fix the drain		8 0
hose to the clip at the back of the washing machine to prevent it from
dropping off.		2.

Note: The drain hose should not be submerged in water

and should be securely fixed and leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less than 80cm, the washing machine will continuously drain while being filled (self-siphoning).

Connecting to the power supply

Before connecting to the power supply, check:

¬The socket is adequate for the maximum power of the washing machine (For safety, fuses in the power circuit should be rated for no less than 15A).

¬The voltage should meet the requirement.

¬The power outlet should be capable of accepting the washing machine plug.

¬Connect the machine to an earthed socket outlet.