Designing an Interface Between a P6434 Probe and a SUT
P6434 Probe Instructions 9
Dimensions and Placement of Compatible Mictor Connectors
You can use compatible surface-mounted or straddle-mounted Mictor connectors
in your circuit board design. The connectors should be placed as close as possible
to the device under test.
The placement of Mictor connectors depends on whether you plan to connect the
P6434 probe directly to the SUT or use the Low-Profile Extender with the probe.
Figure 7 shows the dimensions and minimum placement of surface-mounted
connectors on a SUT. The side-to-side dimension between connectors also
applies to the straddle-mounted connector.
31.75 mm
(1.250 in)
10.80 mm
(.425 in)
31.50 mm
(1.240 in)
9.90 mm
(.390 in)
6.35 mm
(.250 in)
Pin 1
Figure 7: Dimensions and placement of a surface-mounted Mictor connector with
latch housing
The vertical clearance dimension for the probe is 1.25 inches. Figure 14 on
page 21 shows this dimension.

Direct Connection