Example 1: Displaying a Waveform
Getting Started
2. Press the button directly below the Recall Factory Setup menu item.
The display shows
side menus
along the right side of the screen. The
buttons to select these side menu items are to the right of the side menu.
Because an accidental instrument reset could destroy a setup that took a
long time to create, the digitizing oscilloscope asks you to verify the
Recall Factory Setup selection (see Figure 1-5).
3. Press the button to the right of the OK Confirm Factory Init side menu
item.
NOTE
This manual uses the following notation to represent the sequenceof selections you made in steps 1, 2 and 3:
Press save/recall SET-
UP ➞ Recall Factory Setup (main) ➞ OK Confirm Factory Init
(side).
Note that a clock icon appears on screen. The oscilloscope displays this
icon when performing operations that take longer than several seconds.
4. Press SET LEVEL TO 50% (see Figure 1-6) to be sure the oscilloscope
triggers on the input signal.
SET LEVEL TO 50% Button
Figure 1-6: Trigger Controls