EDIT Menu

Setting Data to High/Low. Use Set High and Set Low to set the data lines or marker in the area designated by the right and left vertical bar cursors to either High or Low.

1.Select Set... from the side menu displayed.

2.Press the CURSOR button on the front panel.

3.Using the general purpose knob, move the vertical bar cursors to designate the area for the High or Low state.

4.Select Line from the sub-menu. Using the general purpose knob, select the data line (DATA 11 ± DATA 0) or the marker (MARKER) that you want to set to High or Low.

5.Select Set High or Set Low to set the state between the vertical bar cursors for the selected line.

Set High Sets the state to High

Set Low Sets the state to Low

Figure 3 -80 shows an example in which the state of the DATA 5 line between the vertical bar cursors has been set to Low.

Figure 3 ￿80: Setting Waveform Data to High/Low

6.Select Go Back from the current sub-menu. The system moves from the Set... sub-menu to the previous side menu.

AWG2021 User Manual

3 ￿105