EDIT Menu

3.Press Draw Area in the sub-menu and select Mag (magnitude) or Phase (phase).

4.Press the VALUE button on the front panel. Using the general purpose knob, move the point cursor to the location of the new point. Pressing the VALUE button will toggle the direction of movement from horizontal (X) to vertical (Y) and vice-versa. The location of the point cursor is displayed in the upper right-hand corner of the screen in X (frequency) and Y (magnitude or phase) coordinates.

5.When you have placed the point cursor at the desired location, select Add Draw Point from the sub-menu to add a point at that location.

It is possible to add points outside the area defined by the vertical bar cursors. However, such points will be ignored when Execute is pressed.

NOTE. It is not possible to draw more than one point at the same location on the horizontal axis. If you attempt to do this, a message will appear asking you to confirm that you want to change the level of the existing point. Press O.K. or Cancel in response to this message.

6.Repeat Steps 4 and 5 to add several new points.

7.To delete a point that you have added with Add Draw Point, move the point cursor to that point and select Delete Draw Point. The point will be deleted.

If you press Delete Draw Point several times in succession, the points that you have added will be deleted in sequence starting with that nearest to the point cursor.

8.Select Execute from the sub-menu. The points that you have added will be connected to the magnitude or phase on the left and right vertical bar cursors.

Figure 3 -145 shows an example of a magnitude drawn between the vertical bar cursors.

AWG2021 User Manual

3 ￿203