Left Bracket for 19-in. Rack

Remove Screws (4) on Each

Side of Panel to Remove

Brackets from Stowed Position

Right Bracket for 23-in. Rack

Right Bracket for 19-in. Rack

Left Bracket for 23-in. Rack

Panel With Mounting Brackets in Stowed Position for Shipping

3.Select the proper pair of brackets and discard the other two.

4.Mount brackets to sides of panel, as shown in the following examples. Tighten screws to about 29 in.-lb (~3.3 N•m).

Panel can be mounted so that panel’s face is flush or extended in 0.5-in. (12.7 mm) increments from rack. (The clover-leaf pat- tern on the face of the bracket points downward on the right side of the panel and upward on the left.)

Bracket for a 19-in. Rack (Extended 2 in.)

Bracket for a

Bracket for a

 

23-in. Rack

19-in. Rack

Clover-Leaf Pattern Points Downward

(Flush Mount)

(Flush Mount)

on Right Side of Panel.

Bracket Installation (Examples)

5.Locate an unused rack position and mount panel using four, 12-24 thread-cut- ting screws and lockwashers provided, as shown on the right. Tighten screws to 35 in.-lb (4.29 N•m).

6.Before connecting any conductor, use a multimeter to measure the resistance

between the input terminal of each side (+A and -A for Side A; +B and -B for Side B) at the rear corner of the panel. Expect 500Ω or more for both Side A and Side B.

Telect, Inc. • USA +1.509.926.6000 • Mexico +52.33.3836.3700

 

Poland +48.713.239.100 • UK +44.1489.889500 • www.telect.com

Page 4

Copyright © 2006 Telect, Inc., All Rights Reserved • 130358-2 A0