4 Service | BCS II Simplex Repeater User Manual |
Flat surface of LED to flat surface of socket
Leads
LED
4.When the LED snaps into place, the installation is complete.
5.To test the new LED, insert a plug into the “M” (monitor) jack. The LED flashes for about 30 seconds, then lights steadily.
IN CASE OF DIFFICULTY
If problems occur after initial installation, check all cable connections and the installation instructions in Chapter 2.
Technical Support
By
By phone:
IN-WARRANTY SERVICE
Contact your Telect equipment distributor, or call a Telect Customer Service Representative:
Telect will repair or replace defective products within the limits of the warranty. See “Repacking for Shipment” in this section.
NOTE
Call a Customer Service Representative for a Return Material Authorization (RMA) before returning any equipment.
Telect, Inc. |