BCS II Simplex Repeater User Manual | 2 Installation |
6.Slide each module into the appropriate chassis slot and press it firmly into the backplane connector.
7.Secure each module with the included screw.
8.Follow the diagram below to connect two network elements.
Simplex Repeater
LBO Settings
Distance | Distance | Distance |
A | B | C |
NE
RX
TX
I | I |
| |
IX | IX |
| |
O | O |
|
NE
RX
TX
OX | OX |
SIMPLEXSIMPLEX
REPEATERREPEATER
Each network element can be located up to 900ft. from the far end repeaters IX port.
(using
| Repeater |
|
| Repeater |
|
| |
|
|
| to |
|
| ||
| to NE |
| Transmit | Repeater |
| Receive | |
| distance | FIGURE | LBO | distance | FIGURE | LBO | |
CABLE | (feet) | Distance | Setting | (feet) | Distance | Setting | |
720 | A or C | SHORT | B | SHORT | |||
A or C | LONG | B | LONG | ||||
| |||||||
728 | A or C | SHORT | B | SHORT | |||
A or C | LONG | B | LONG | ||||
| |||||||
734 | A or C | SHORT | B | SHORT | |||
A or C | LONG | B | LONG | ||||
| |||||||
735 | A or C | SHORT | B | SHORT | |||
A or C | LONG | B | LONG | ||||
| |||||||
A or C | SHORT | B | SHORT | ||||
A or C | LONG | B | LONG | ||||
|
9.Install backplane tracer lamp wire between the two repeaters and verify both tracer lamp LEDs light.
10.Install designation strips and label them using office standards.
11.Test circuits per office standards.