Getting Started Teledyne API - Model 200EH/EM Operation Manual
14
3.1.2.5. Connecting the Serial Ports
If you wish to utilize either of the analyzer’s two serial interfaces, refer to Section 6.11 and 6.15 of this manual for
instructions on configuration and usage.
3.1.2.6. Connecting to a LAN or the Internet
If your unit has a Teledyne Instruments Ethernet card (Option 63), plug one end of a 7’ CAT5 cable into the
appropriate place on the back of the analyzer (see Figure 5-11 in Section 5.9.3) and the other end into any
nearby Ethernet access port.
NOTE:
The M200EH/EM firmware supports dynamic IP addressing or DHCP.
If your network also supports DHCP, the analyzer will automatically configure its LAN
connection appropriately,
If your network does not support DHCP, see Section 6.11.6.3 for instructions on
manually configuring the LAN connection.
3.1.2.7. Connecting to a Multidrop Network
If your unit has a Teledyne Instruments RS-232 multidrop card (Option 62), see Section 6.11.7 for instructions
on setting it up.
CAUTION
To prevent dust from getting into the analyzer, it was shipped with small plugs inserted
into each of the pneumatic fittings on the rear panel. Make sure that all dust plugs are
removed before attaching exhaust and supply gas lines.
04521C (DCN5731)