Materials exposed to Vacuum | Teledyne IGE 3000 specification

2.4.Materials exposed to Vacuum

•Yttia coated Iridium

•Nickel

•304 Stainless Steel

•Glass

•Tungsten

•Platinum Clad Molybdenum

169-082010_Ion-Gauge-3000

Page 7 of 21

Image 7

Teledyne IGE 3000 instruction manual Materials exposed to Vacuum

Contents

Teledyne Hastings Manual Print History Table of Contents 169-082010Ion-Gauge-3000 To Turn on the TUBE’S Filaments Quick Start Information IGE-3000 Mini Bayard/Alpert B/A Tube SpecificationsGeneral Information General Information Materials exposed to Vacuum Mounting InstallationInstallation Receiving Inspection Environmental Connector Electrical Pin outsB/A Tube Installation Mounting B/A tube to IGE-3000 Electronics Module Front Panel Overview Apply PowerOperation Operation Operating Modes SP set point Mode DGas ModeFactor Mode Fil filament Mode Remote Filament Control Bayard Alpert B/A Tube Theory of Operation Baud Rate Set Up GuideAdvance Setup Guide RS485 Address Save Eeprom Turnaround DelayRestore Eeprom Data Bits/Parity Bits/Stop Bits RS 232/RS Wiring for IGE-3000 RS232/485 Wiring for RS232/485RS232/RS485 Device Status Command SyntaxION Gauge Device Status 4-DIGIT Octal Word Parameter Modification Commands Interrogation CommandsCommand Description Format Sample Response Non-Warranty Repair Policy Warranty Repair Policy Drawings & Schematics