Teledyne TED 191 S ECTION T HREE CLEANING AND S

15

TELEDYNE ELECTRONIC TECHNOLOGIES

Analytical Instruments

SECTION THREE CLEANING AND STERILISATION

3.1 CLEANING THE TED 191 PORTABLE OXYGEN MONITOR

The instrument itself should be cleaned using a damp cloth. In the event of an excessive

build-up of dirt, a mild alcohol solution (isopropyl) may be used t o wipe over the instrument,

which should be allowed to air-dry afterwards. In extreme cases, the monitor casing may be

cleaned using a mild detergent.

Note: The Accurox Oxygen monitor cannot be liquid sterilised or autoclaved –

irreparable damage may result.

3.2 STERILISING THE T-7 OXYGEN SENSOR AND CONNECTING CABLE

The T-7 oxygen sensors and connecting cables used on the instrument m ay be gas

sterilised using low temperature ethylene oxide. A vacuum must not be drawn on the

sensor during the sterilisation process.

Contents

Main TED ' PORTABLE OXYGEN MONITOR INSTRUCTION MANUAL Page T ABLE OF C SECTION TOPIC PAGE NUMBER I A LO HI X 21 TELEDYNE D ESCRIPTION OF F UNCTIONAL Z FRONT PANEL D ESCRIPTION OF F UNCTIONAL Z REAR PANEL SECTION ONE 1.1 SET-UP 1.2 INSTALLING THE BATTERIES 1.3 INSTALLING THE OXYGEN SENSOR 1.4 CALIBRATE THE INSTRUMENT 1.5 NORMAL OPERATION 1.6 SET THE ALARMS Oxygen Mo nitor S ECTION T WO ANAESTHETIC A Gas or Vapor Level S ECTION T HREE CLEANING AND S 3.1 CLEANING THE TED 191 PORTABLE OXYGEN MONITOR 3.2 STERILISING THE T-7 OXYGEN SENSOR AND CONNECTING CABLE SECTION FOUR DOS AND DONTS D O D ON SECTION FIVE ROUTINE MAINTENANCE 5.1 ROUTINE VISUAL INSPECTION 5.2 CHANGING BATTERIES 5.3 CHANGING THE OXYGEN SENSOR CELL SECTION SIX TROUBLESHOOTING T S ECTION S EVEN TECHNICAL S T ECHNICAL S S ECTION E IGHT EFFECT OF P SECTION NINE EFFECT OF H SECTION TEN E T SECTION ELEVEN D ISCREPANCY IN R SECTION TWELVE REPAIR S R EPLACEMENT L T ECHNICAL S ERVICE L Page SPARE PAR TS L SPARE PARTS O PTIONAL A