Telenetics DSP9612RM manual Configuring the Modem

Configuring the Modem

Table 2-1. Modem Switch Settings for High-Speed Mode

Switches	Switch Settings
	ON	OFF (Default)
SW 1-1 − 1-4: Transmit Level (page 14)	(see Table 2-2 on page 14)
SW 1-5: Receiver Dynamic Range	−10 to −43 dBm	+3 to −30 dBm
(page 15)
SW 1-6: TX Cable Equalizer (page 15)	Enabled	Disabled
SW 1-7: RX Cable Equalizer (page 15)	Enabled	Disabled
SW 1-8: Anti-streaming (page 15)	Active	Inactive
SW 2-1: High-Speed/Low-Speed Mode	Low-Speed Mode	High-Speed Mode
(page 16)	(FSK)	(Fast Poll)
SW 2-2: Data Rate in Fast Poll Mode	4800 bps	9600 bps
SW 2-3: Async Character	11 bits	10 bits
SW 2-4: Auto RTS (page 16)	Enabled	Disabled
SW2-5: Reserved
SW 2-6: Production Test Only (page 16)	Test	Normal
SW 2-7: 2- or 4-wire (page 16)	2-wire, half-	4-wire, full-duplex
	duplex
SW 2-8: Carrier Control (page 17)	Constant	Switched
SW 2-9: Rx Termination (page17)	Disabled	Enabled
SW 2-10: Ground Options (page 17)	Chassis Ground-	Chassis Ground-
	Signal Ground	Signal Ground
	Connected	Disconnected

Page 13