WARNING
The following instructions are for use by qualified personnel only. To avoid electric shock, do not remove the cover unless you are qualified to do so.
AVERTISSMENT
Les instructions qui suivent s’adressent uniquement a un technicien qualifie. Pour evite des chocs electriques, ne pas ouvrir le boitier, a moins d’y habilite.
Configuration Pre-check
Before making connections, read the configuration notes that follow, and make sure that all switches and jumpers are properly set for your intended usage. Locations of configuration switches and jumpers are shown in Figure 2. Only the DIP switches and jumpers require internal access. If access is required, remove three screws from the top cover and three screws along the bottom edge from each side.
DIP Switches
DIP switches and their default settings are listed in Table 1. The following paragraphs provide additional details.
Program Interrupt DIP Switches
Each intercom channel has a dedicated program input. These can be used to feed background music,
Audiocom Call Send and Receive DIP Switches
By default, all channels of the
Balanced/Unbalanced Switch
The switch is located on the back panel. The switch must be set to the balanced (BAL) position for use with an Audiocom Intercom System. Set the switch to the unbalanced (UNBAL) position when using the unit with a Clear- Com Intercom System.
Direct Program Listen Enable/Disable Jumpers
By default, each program input can be heard by intercom stations on the corresponding intercom channel. (This can be turned on or off for each program input via the
Sidetone Trimmers
These trimmers are normally adjusted after all components are connected, and they can be accessed through the bottom cover as depicted in Figure 3. Refer to the
6