Table 2 -
Mounting Configurations
The
When rack mounting components, you may not be able to access the sidetone trimmers after the components have been mounted. In this case, you can position the components in the rack and make all required connections. Then adjust the sidetone trimmers before installing and tightening all rack mount screws.
Connection Notes
Typical connections for the
Cables
The numbers below correspond to the cable numbers in the connection drawing in Figure 3.
1.Single channel intercom cable. Sold separately. Use Telex “ME” cables, below, or can also be built by using two twisted pairs in a shielded cable: Pair 1 in used for pins 2 and 3. Pair 2 has both wires connected to pin 1.
2.Shielded patch cable,
Shack, etc. Note: All pins must be connected straight through (i.e. pin 1 to pin 1, pin 2 to pin 2, etc...).
3.Shielded patch cable, stereo miniplug to stereo miniplug. Customer local purchase. Available at Radio Shack, etc...
4.18” (457 mm) EXP IN/OUT cable, stereo miniplug to stereo miniplug. One supplied with each
5.Shielded audio cable. Must have male
Pin 1: common
Pin 2: + program input
Pin 3: - program input
6.Shielded audio cable. Must have male
Pin 1: common
Pin 2: + PA output
Pin 3: - PA output
8