Manuals / Telex / Computer Equipment / Power Supply

Telex MS2002 manual Installation, Unpacking, Configuration Pre-check, Description

Models: MS2002

1 23

Download 23 pages 2.89 Kb

Page 6

Installation

Installation

Unpacking

The package contains the following items. Contact the shipper or your Audiocom dealer immediately if anything is damaged or missing. Detach and fill out the registration card and return it to Telex to properly register your MS-2002.

Qty	Description

1MS-2002 Master Station and Power Station

1Warranty and Registration Card

1User Manual

2 Black Face Plates

WARNING

The following instructions are for use by qualified personnel only. To avoid electric shock, do not remove the cover unless you are qualified to do so.

AVERTISSEMENT

Les instructions qui suivent s’adressent uniquement a un technicien qualifie. Pour evite des chocs electriques, ne pas ouvrir le boitier, a moins d’y entre habilite.

Configuration Pre-check

Before connecting the MS-2002 make sure that it is properly configured for your intended usage. Figure 2 shows the locations of the configuration switches. To access internal switches, remove three screws from the top cover and three screws from the bottom portion of each side.

6

Image 6

Telex MS2002 Installation, Unpacking, Configuration Pre-check, Description, 1 MS-2002 Master Station and Power Station

Contents

Model MS-2002 Master Station and Power Supply Audiocom Intercom SystemsUser Instructions RETURN SHIPPING INSTRUCTIONS Procedure for Returns FCC StatementWARRANTY INFORMATION Shipping to Manufacturer for Repair or AdjustmentInstallation ContentsFeatures DescriptionFeatures Description20. EXPANSION OUT CONNECTOR Connects to an EMS4001 Expansion Station 11. INTERCOM LISTEN KEYS Momentary or latching operation possible19. PA OUTPUT Connects to a public address system Unpacking InstallationConfiguration Pre-check 1 MS-2002 Master Station and Power StationSwitch # Figure 2 - Locations of Configuration Jumpers and SwitchesTable 1 - Configuration Switch Settings SettingsProgram Interrupt DIP Switches Headset Microphone Type Selection DIP SwitchMic Kill Send Enable DIP Switch Incoming Call Beep DIP SwitchesMounting Balanced/Unbalanced SwitchesDirect Program Listen Enable / Disable Jumpers ConnectionsCables Figure 3 - MS-2002 Monaural Master Speaker Station Configuration Figure 4 - MS-2002 Binaural Master Speaker Station Configuration Figure 5 - MS-2002 typical Speaker Station and Belt Pack Connections Figure 6 - External Audio Input and PA Output “Y” CABLE WIRING TYPICAL 1-CHANNEL CABLE WIRINGTYPICAL 2-CHANNEL CABLE WIRING Figure 7 - Audiocom Intercom CablesPower-Up Check Sidetone AdjustmentTest Tone Voice-Activated Microphone Vox Setup Operation2. When you hear a response, release the Call key Public Address PA Using Mic KillUsing Voice-Activated Microphone Vox Incoming Call Beep On/OffDynamic-mic Headset SpecificationsGeneral Panel Microphone InputOutput Level 1 Vrms nominal Input Impedance 300 ohms Expansion Input /Output PA OutputSpeaker Output Headphone AmplifierQuick Reference D ESCRIPTIONA CTION